Vermona fourMulator - quad modulation engine Uživatelský manuál

fourMulator - Owner's Manual

(2) SPEED- and SPEED/PHASE controlsThe SPEED control adjusts the modulators' speed. SPEED covers a rangefrom approx. 0.05Hz to 100Hz. Therefore,

For modulators being synchronized and being shifted in phase, the LEDflash with the same tempo but with a corresponding delay.(3) SYNC-switchThe SYNC

bar. Therefore, the clock division needs to be regarded relatively tothis base.With a clock signal based upon quarter impulses, the eight availablecli

Inputs and OutputsEach modulator offers four jacks to be connected to other modules.(4) WAVEThis jack outputs the selected wave form. Connect this out

(9) Clock output (CLK OUT)This jack outputs the clock signal. It can be connected to modules suchas step-sequencers, clock dividers or sequential swit

Using the fourMulatorfourMulator can act as a control- and clock-central. However, this onlymakes sense in combination with other modules. The followi

Picture 5: Patch Example - CrossmodulationClock yourselffourMulator offers the possibility to enter the clock tempo using the TAPbutton. However, cont

• Doepfer: A-150/A-151/A-152 Switches, A-160 Clock Divider, A-161Clock Sequencer• Intellijel Designs: µStep-sequencer• Make Noise: Brains• The Harvest

Declaration of ConformityWe declare under our sole responsibility that this product is in confor-mity with the following standards or standardization

IntroductionDo you really need four LFO units in single module? Let's "fourMulate" itlike this: You cannot really have enough LFOs, can

Important Safety Information1. Read these instructions.2. Keep these instructions. Alway include these instructions when pas-sing the product on to th

17. Do not expose this equipment to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on the equipment.1

Table of Contents1 Introduction 2...2 Important Safety

Getting StartetTo ensure top quality, we carefully inspected the module before packag-ing. Nevertheless, the unit could have been damaged during trans

Picture 1: Connecting the fourMulator to the system bus4. Mount the fourMulator to your modular frame. The unit requires awidth of 34 HP (horizontal p

A fourMulator – what is it?Simply described, Vermona's fourMulator is a quadruple LFO, with allLFO units (modulators) being able to run freely or

Connections and ControlsPicture 2: Controls and Connectors of the fourMulatorControl elements of the four modulatorsThe LFOs/modulators in the fourMul